Computer Problems
Tibs
09-28-2005, 01:47 PM
#6
Member No. 342 · 95 posts · joined 2-September 05 · Members

here's a copy and paste of what I put in the matrixls forums: ^_^
.......................................................................
Ok on your personal pc, heat is very bad... very very bad (though I'm sure you knew that ). I have a feeling that your processor sustained a small amount of heat related damage, thus why you are having weird and unpredictable issues. Video card GPU's seem to be a little more tolerance of heat and usually you'll have a capacitor bust on a video card before the GPU takes any damage (key word 'usually'), so most likely your video card should still be fine.

I would try and find another CPU that your motherboard supports (even if just a loaner) to try it out. If everything comes up fine after that then you have found your culpret. If you get everything running but you get artifacts or anomalies in any 3D intesive app, then you might find a video overclocking app for the GPU chipset you have and underclock it some (as most of these utilities will allow for underclocking as well). I have found that doing this can make flakie video cards work satisfactory.

You might also manually underclock your CPU via either the bios or your motherboard (depending on what you have) and see if that helps any as well. I would personally lower the FSB and not the multiplier (that way your not having to try more variations of underclocking than neccessary)
................

ok, on the network setup... my 1st question is, are the pc's that can't connect to the internet pulling an IP address of 169.254.xxx.xxx with a subnet mask of 255.255.0.0? If so, then that means these pc's cannot connect to a DNS. When windows cannot communicate to a DNS it resets the IP and subnet mask so it can at least talk with any other pc's connected to the same network (that also cannot connect to a DNS). Also, get on 1 problem pc and try to ping another problem pc, that way you can verify if the router is even remotely doing it's job.

On the router itself, check the various settings including port forwarding... cause if it's forwarding port 80 to the wireless pc then only that pc will be able to surf the web. Also, most routers have a hard reset that resets everything back to factory defaults. This usually entails putting the end of a paperclip in a hole, powering it off, powering it back on and then removing the paper clip from the hole... this of course various from router to router.

Hope this helps, if you have any other info to provide that you think may be usefull then feel free to post it.

~Tibs
Go to the top of the page


Messages In This Thread
Computer Problems - by STUFF - 09-28-2005, 08:11 AM
Computer Problems - by White Knight - 09-28-2005, 09:22 AM
Computer Problems - by STUFF - 09-28-2005, 09:40 AM
Computer Problems - by White Knight - 09-28-2005, 11:20 AM
Computer Problems - by Tibs - 09-28-2005, 01:34 PM
Computer Problems - by Tibs - 09-28-2005, 01:47 PM
Computer Problems - by STUFF - 09-28-2005, 07:59 PM
Computer Problems - by STUFF - 10-06-2005, 07:33 AM
Computer Problems - by crazybeans128 - 10-06-2005, 04:15 PM
Computer Problems - by Tynvar - 10-06-2005, 05:21 PM
Computer Problems - by crazybeans128 - 10-06-2005, 05:29 PM
Computer Problems - by White Knight - 10-07-2005, 01:23 PM
Computer Problems - by Kasumi - 10-18-2005, 07:48 AM
Computer Problems - by White Knight - 10-18-2005, 09:02 AM
Computer Problems - by elfboy382 - 11-04-2005, 08:57 PM
Computer Problems - by White Knight - 11-05-2005, 01:55 AM
Computer Problems - by crazybeans128 - 11-05-2005, 04:55 PM
Computer Problems - by White Knight - 11-06-2005, 06:21 AM
Computer Problems - by crazybeans128 - 11-06-2005, 11:15 AM
Computer Problems - by White Knight - 11-06-2005, 11:40 AM
Computer Problems - by crazybeans128 - 11-06-2005, 11:46 AM
Computer Problems - by elfboy382 - 11-07-2005, 09:10 PM
Computer Problems - by skullz - 11-08-2005, 02:52 PM
Computer Problems - by White Knight - 11-08-2005, 04:16 PM
Computer Problems - by crazybeans128 - 11-08-2005, 06:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)